欢迎访问中科光析科学技术研究所官网!

免费咨询热线
400-625-0567|
稀土类示踪剂检测项目报价? 解决方案? 检测周期? 样品要求? |
点 击 解 答 ![]() |
本标准规定了大洋多金属结核调查的基本内容、方法、样品测试和处理、试验测试技术和调查成果等技术内容。 本标准适用于大洋多金属结核勘查和室内的测试,对某些如铁锰结壳的调查也可参照使用。
ISO 15366-1:2014 describes procedures to chemically separate and purify uranium and plutonium in dissolved solutions of irradiated light water reactor fuels and in samples of high active liquid waste of spent fuel reprocessing plants, prior to their isotopic analysis by e. g. mass spectrometric method or alpha spectrometry. ISO 15366-1:2014 describes a technique for the separation of uranium and plutonium in spent fuel type samples based on chromatographic method. The procedure applies to samples containing 1 µg to 150 µg Pu (IV) and (VI) and 0,1 mg to 2 mg U (IV) and (VI) in up to 2 ml of 3 mol·l-1 nitric acid solution. It is applicable to mixtures of uranium and plutonium in which the U/Pu-ratio can range from 0 up to 200.
ISO 15366-2:2014 describes procedures to chemically separate and purify uranium and plutonium in dissolved solutions of irradiated light water reactor fuels and in samples of high active liquid waste of spent fuel reprocessing plants, prior to their isotopic analysis by e. g. mass spectrometric method or alpha spectrometry. ISO 15366-2:2014 describes a slightly different separation technique from ISO 15366-1, based on the same chemistry, using smaller columns, different support material and special purification steps, applicable to samples containing plutonium and uranium amounts in the nanogram range and below. The detection limits were found to be 500 pg plutonium and 500 pg uranium.
前沿科学
微信公众号
中析研究所
抖音
中析研究所
微信公众号
中析研究所
快手
中析研究所
微视频
中析研究所
小红书