IEC61851-1中模式4不含热管理系统直流充电用额定电压0.6/1 kV及以下电缆检测

IEC61851-1中模式4不含热管理系统直流充电用额定电压0.6/1 kV及以下电缆检测项目报价？  解决方案？  检测周期？  样品要求？

点 击 解 答

IEC 61851-21-1-2017电动车辆传导充电系统. 第21-1部分: 传导连接到交流/直流电源上的电动车辆车载充电机EMC要求

This part of IEC 61851, together with IEC 61851-1:2010, gives requirements for conductive connection of an electric vehicle (EV) to an AC or DC supply. It applies only to on-board charging units either tested on the complete vehicle or tested on the charging system component level (ESA - electronic sub assembly). This document covers the electromagnetic compatibility (EMC) requirements for electrically propelled vehicles in any charging mode while connected to the mains supply. This document is not applicable to trolley buses, rail vehicles, industrial trucks and vehicles designed primarily to be used off-road, such as forestry and construction machines. NOTE 1 Specific safety requirements that apply to equipment on the vehicle during charging are treated in separate documents as indicated in the corresponding clauses of this document. NOTE 2 Electric vehicle (EV) includes pure electric vehicles as well as plug-in hybrid electric vehicles with additional combustion engine.

IEC 61851-21-2-2018电动汽车导电充电系统. 第21-2部分: 交流/直流电源导电连接的电动汽车要求. 车外电动汽车充电系统的电磁兼容性要求

This part of IEC 61851 defines the EMC requirements for any off-board components or equipment of such systems used to supply or charge electric vehicles with electric power by conductive power transfer (CPT), with a rated input voltage, according to IEC 60038:2009, up to 1000 V AC or 1500 V DC and an output voltage up to 1000 V AC or 1500 V DC. This document covers off-board charging equipment for mode 1, mode 2, mode 3 and mode 4 charging as defined in IEC 61851-1:2017. Cables where there is no electronics or no electric/electronic switching are considered as passive (benign) and are deemed to comply with the emission and immunity requirements of this document without any need for testing. This document does not apply to any on-board components or equipment of charging or power supply systems being part of the vehicles. The EMC requirements for such equipment are covered by IEC 61851-21-1: 2017. Compliance with the emission and immunity requirements of this document is verified where it can be demonstrated that the equipment under test (EUT) meets the respective limits, during type tests in the measuring arrangement of this document. Requirements for electric vehicle wireless power transfer (WPT) systems are covered in IEC 61980 (all parts).

IEC 61851-24-2023

This part of IEC 61851, together with IEC 61851-23, applies to digital communication between a DC EV supply equipment and an electric road vehicle (EV) for control of conductive DC power transfer, with a rated supply voltage up to 1000 V AC or up to 1500 V DC and a rated output voltage up to 1500 V DC. This document also applies to digital communication between the DC EV charging/discharging station and the EV for system A, as specified in Annex A. The EV charging mode is mode 4, according to IEC 61851-23. Annex A, Annex B, and Annex C give descriptions of digital communications for control of DC charging specific to DC EV charging systems A, B and C as defined in IEC 61851-23.