壁挂式洗衣机检测

GB/T 11228-2008住宅厨房及相关设备基本参数

本标准规定了住宅厨房及其相关设备基本参数和厨房设备与厨房设施的范围、术语和定义、分类、要求。本标准适用于有供水、排水、电气、燃气设施等管线的新建、改建城镇住宅厨房及相关设备的基本参数。

GB/T 16662-2008建筑给水排水设备器材术语

本标准规定了建筑给水排水设备和器材，包括卫生器具，水嘴，加压、调节和贮存设备，加热贮热设备，地漏，检查井，建筑水处理设备，游泳池、游乐池设备，冷却设备，水景设备，雨水利用设备，管材，管件，阀门，计量、检测仪表等方面的专用术语。本标准适用于建筑给水排水设备和器材的专用术语。

GB/T 32928-2016电子商务交易产品信息描述 家用电器

本标准规定了电子商务交易中家用电器类产品信息的描述属性与方法、模型、摘要描述以及扩展方法。本标准适用于电子商务中家用电器类产品信息的发布、交换、存储和管理等。

GB 50096-2011住宅设计规范

为保障城镇居民的基本住房条件和功能质量，提高城镇住宅设计水平，使住宅设计满足安全、卫生、适用、经济等性能要求，制定本规范。本规范适用于城镇新建、改建和扩建住宅的建筑设计。住宅设计必须执行有关方针、政策和法规，遵守安全卫生、环境保护、节约用地、节约能源资源等有关规定。 住宅设计除应符合本规范外，尚应符合现行有关标准的规定。

CECS 307-2012加强型旋流器特殊单立管排水系统技术规程

本规程适用于新建、扩建和改建的高层及多层民用建筑加强型旋流器特殊单立管排水系统的设计、施工及验收。

CJ/T 363-2011建筑同层排水部件

本标准规定了建筑同层排水主要部件的管材和管件、卫生器具、隐蔽式安装部件、地漏和存水弯的试验方法、检验规则、标志和标识、包装、运输和贮存。本标准适用于民用和工业建筑同层排水部件的设计、生产和检测。

UL 1574-2004道路照明系统

1.1 These requirements cover track lighting systems intended for permanent connection to sources of supply in commercial or residential ordinary locations in accordance with the National Electrical Code, NFPA 70. The track lighting systems covered by this standard are rated: a) 300 volts or less; b) 150 volts or less to ground; and c) 50 amperes or less. 1.2 Lighting track is intended to be permanently installed and permanently connected to a branch circuit not exceeding 277 volts, nominal to ground, and 50 amperes. 1.3 These requirements cover: a) Track networks consisting of track and connectors; b) Mono-, duo-, and multi-point canopies; c) Incandescent, fluorescent, and High Intensity Discharge (HID) luminaire assemblies intended to be electrically connected to and physically supported by the track in track networks and canopies; d) Mounting means for the track; and e) Accessories. 1.4 These requirements do not cover: a) Busways intended for lighting, receptacles, or other general-purpose adaptors covered by the Standard for Busways, UL 857, and intended for use in accordance with Article 364 of the National Electrical Code, NFPA 70; or b) Track lighting systems for marine use aboard a ship or boat. 1.5 Track lighting systems are not intended for use: a) In wet or damp locations; b) In installations where the track is concealed; c) In hazardous locations; d) Where subject to physical damage; e) Where the track is extended through walls or partitions of building structures; f) Where subject to corrosive vapors; or g) In storage battery rooms. 1.6 A track lighting luminaire assembly that uses a tungsten-halogen lamp, fluorescent lamp, or high-intensity-discharge lamp shall also comply with the applicable requirements from the Standard for Luminaires, UL 1598.

UL 60335-2-8-2004家用和类似用途电器的安全.第2部分:电动剃须刀、电推子和类似电器的特殊要求

This clause of Part 1 is replaced by the following.This International Standard deals with the safety of electric shavers, hair clippers and similar appliances intended for household and similar purposes, their RATED VOLTAGE being not more than 250 V.Examples of similar appliances are those used for manicure, and pedicure. Appliances not intended for normal household use, but which nevertheless may be a source of danger to the public, such as appliances intended to be used by laymen in shops and on farms, are within the scope of this standard.Examples of such appliances are animal clippers, animal shearers and appliances for hairdressers.As far as is practicable, this standard deals with the common hazards presented by appliances that are encountered by all persons in and around the home. However, in general, it does not take into account: the use of appliances by young children or infirm persons without supervision; playing with the appliance by young children. Attention is drawn to the fact that: for appliances intended to be used in vehicles or on board ships or aircraft, additional requirements may be necessary; in many countries additional requirements are specified by national health authorities, national authorities responsible for the protection of labour and similar authorities. This standard does not apply to: appliances intended to be used in locations where special conditions prevail, such as the presence of a corrosive or explosive atmosphere (dust, vapour or gas); massage appliances (IEC 60335-2-32); appliances for medical purposes (IEC 60601). 1 Modification of 1DV of the UL part 1: The articulate probe of figure 1DV shall replace the test finger of figure 1 for these products. 1 Modification of the second paragraph of the part 2 by replacement with 1dv.2.1 and 1dv.2.2: 1DV.2.1 These requirements cover hair clippers and shaving appliances to be employed in accordance with the National Electrical Code, NFPA 70. 1DV.2.2 These requirements cover appliances for household or commercial use on persons or animals, and appliances in which motion of an operating part is produced by electrical means. 1DV.2.2 Modification of Note 101 of the part 2 by replacement with the following: These requirements do not cover manicure, pedicure, or personal grooming appliances used for similar purposes. However, hair clipping and shaving appliances supplied with manicure, pedicure, or other similar attachments or accessories are investigated under these requirements and such additional requirements as are applicable to the appliance under consideration. 1DV.2.2 Modification of the third paragraph of the part 2 by replacement with the following: Motor-operated lather makers, lather makers incorporating heaters, barber shop vacuum cleaners for use on persons, and other types of hair clipping and shaving appliances not specifically named here are investigated under these requirements and under such additional requirements as are applicable to the appliance under consideration. 1DV.2.2 Modification of Note 103 of the part 2 to add the following items: for an appliance that utilizes some other source of energy - such as gas or steam - in addition to electric energy, additional requirements may be necessary. Additional requirements applicable to equipment designed for use in hazardous locations as defined in the National Electrical Code, ANSI/NFPA 70, are not included in this standard. 1DV.2.2 Addition to part 2: The values given in SI (metric) units are the standard. The values given in parentheses are for information only.

EN 12354-5-2009建筑声学.通过各元件性能估算建筑物的声学性能.第5部分:服务设备引起的声级

This document describes calculation models to estimate the sound pressure level in buildings due to service equipment. As for the field measurement document (EN ISO 16032) it covers sanitary installations, mechanical ventilation, heating and cooling, service equipment, lifts, rubbish chutes, boilers, blowers, pumps and other auxiliary service equipment, and motor driven car park doors, but can also be applied to others equipment attached to or installed in buildings. The estimation is primarily based on measured data that characterises both the sources and the building constructions. The models given are applicable to calculations in frequency bands.This document describes the principles of the calculation models, lists the relevant quantities and defines its applications and restrictions. It is intended for acoustical experts and provides the framework for the development of application documents and tools for other users in the field of building construction, taking into account local circumstances. The calculation models described use the most general approach for engineering purposes, with a link to measurable quantities that specify the performance of building elements and equipment. The known limitations of these calculation models are described inThis document. Users should, however, be aware that other calculation models also exist, each with their own applicability and restrictions. The models are based on experience with predictions for dwellings and offices; they could also be used for other types of buildings provided the constructional dimensions are similar to those in dwellings.

DIN 4045-2016废水工程.术语

This standard specifies definitions for terms of wastewater engineering, which are not included in the European Standard EN 16323. This standard contains significant terms in the field of wastewater engineering and such terms which were not unambiguous until now.

DIN 85005 Bb.1-2005船舶和海上技术.技术文献的图形符号.索引

This first supplement of the DIN 85005 contains all the standards according to series DIN 85005 approved of series VG 85005 in all their sections. It will increase the transparency to these standards. And helpts make them more understandable to future users. This supplement also has an attached index with all the subsequent specified standards to ease the us age.

DIN EN 1458-1-2012标称热输入不超过6kW的B22D和B23D型家用直接燃气式滚筒干衣机.第1部分:安全

This European Standard specifies the requirements and test methods for the construction, safety and marking of domestic direct gas-fired tumble dryers, of types B22D and B23D, of nominal heat input not exceeding 6 kW, hereafter referred to as \"appliances\". This European Standard does not apply to: a) catalytic combustion appliances; b) appliances designed exclusively for industrial purposes; c) appliances intended to be used in locations where special conditions prevail, such as the presence of a corrosive or explosive atmosphere; d) appliances of the condensing type wherein the heated air and products of combustion used for the drying process are dehumidified by cooling with water or air; e) appliances intended to be used in vehicles or on board ships or aircraft. This European Standard covers type testing only.

ANSI Z124.4-2006塑料抽水马桶和水箱用美国标准

This standard covers physical requirements andtest methods for performance, and dimensions, in addition to general requirements of materials, workmanship and finish of plastic water closets bowls, tanks, tank covers or combinationsof same.The materials and equipment which are listed to conduct the tests in this standard are provided for reference in determining compliance with this voluntary standard. Materials and equipment of similar design, composition, and specificationshall also be permitted to conduct these tests.