婴儿学步车检测

发布时间：2024-06-21 作者：中析研究所浏览：

GB 14749-2006婴儿学步车安全要求

本标准适用于从能够独立坐到能够自己行走的婴儿使用的婴儿学步车（以下简称学步车）的安全要求和测试方法。本标准不适用于医疗用学步车以及气垫支撑婴儿的学步车。婴儿学步车如附有供儿童玩耍的玩具，应符合相关标准要求。

GB/T 22753-2008玩具表面涂层技术条件

本标准规定了玩具表面涂层的技术要求和试验方法。本标准适用于各种具有装饰和防护等功能的玩具表面涂层。本标准不适用于儿童自行车、儿童三轮车、儿童推车、婴儿学步车的表面涂层。

GB 22793.1-2008家具.儿童高椅.第1部分:安全要求

GB 22793的本部分规定了有关家用儿童高椅的安全要求，目的是大限度地减少儿童高椅和用作儿童高椅的多用途高椅在正常使用或合理性可预见误用时导致的事故。本部分不适用于可变换成矮椅，矮椅和矮桌以及具有婴儿学步车、推椅、摇椅、汽车椅和可躺的低椅等高椅的附加功能。本部分不适用于由儿童相互之间在高椅内玩耍可能引起的事故或伤害，或者由3岁以上的儿童滥用或误用时造成的事故。

GB/T 24329-2009出口儿童高椅安全要求及测试方法

本标准规定了出口儿童高椅的安全要求、测试方法及标志、使用说明。本标准适用于供6个月到36个月之间的儿童使用的出口儿童高椅。本标准不适用于以下两种情况：多功能儿童高椅调节成婴儿学步车、推椅、摇椅、汽车座椅及斜躺矮椅等附加功能时；大龄儿童与椅中儿童进行互动或者3岁以上使用者的滥用或不正确使用高椅时。

GB/T 36601-2018电子商务交易产品信息描述玩具

本标准规定了电子商务交易中玩具类产品信息的描述属性、描述方法、信息模型、通用信息摘要描述、专用信息摘要描述以及信息扩展方法。本标准适用于电子商务中玩具类产品信息的发布、交换、存储和管理等。

CNCA 13C-068-2006玩具类产品强制性认证实施规则.童车类产品

本规则适用于设计或预定供儿童乘骑玩耍的童车类产品，包括：儿童自行车(大鞍座高度在435mm～635mm范围内)儿童三轮车儿童推车婴儿学步车玩具自行车(大鞍座高度小于435mm)电动童车其它玩具车辆

QB/T 2121-2014童车涂层通用技术条件

本标准规定了童车产品(包括儿童自行车、儿童三轮车、儿童推车、婴儿学步车)表面涂层的术语和定义、要求、试验方法。本标准适用于各种具有装饰和防护等功能的童车表面涂层。

SN/T 0729-2014进出口童车检验规程

本标准规定了进出口童车的抽样、检验和检验结果的判定的规则。本标准适用于儿童自行车、儿童三轮车、儿童推车、婴儿学步车的检验。儿童乘骑的童车独轮车、鞍座高度高于435 mm的滑行车、滑板车等的检验可参照本标准执行。本标准不适用于电动童车和其他类童车的检验。

ASTM F977-2000婴儿学步车的用户安全使用标准规范

1.1 This consumer safety specification covers performance requirements, test methods, and marking requirements to promote safe use of the baby walker (see 3.1). 1.2 This consumer safety specification is intended to minimize accidents to children resulting from normal use and reasonably foreseeable misuse or abuse of walkers. 1.3 No walker produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein. 1.4 This consumer safety specification is not intended to address accidents and injuries resulting from the interaction of other persons with the child in the walker or the accidents resulting from abuse and misuse by children able to walk.1.5 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.1.6 The following precautionary caveat pertains only to the test method portion, Section 7, of this consumer safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM F977-2003婴儿学步车的用户安全使用标准规范

1.1 This consumer safety specification covers performance requirements, test methods, and marking requirements to promote safe use of the infant walker (see 3.1).1.2 This consumer safety specification is intended to minimize accidents to children resulting from normal use and reasonably foreseeable misuse or abuse of walkers.1.3 No walker produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein.1.4 This consumer safety specification is not intended to address accidents and injuries resulting from the interaction of other persons with the child in the walker or the accidents resulting from abuse and misuse by children able to walk.1.5 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.1.6 The following precautionary caveat pertains only to the test method portion, Section 7, of this consumer safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM F977-2009婴儿学步车安规

1.1 This consumer safety specification covers performance requirements, test methods, and marking requirements to promote safe use of the infant walker (see 3.1). 1.2 This consumer safety specification is intended to minimize accidents to children resulting from normal use and reasonably foreseeable misuse or abuse of walkers. 1.3 No walker produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein. 1.4 This consumer safety specification is not intended to address accidents and injuries resulting from the interaction of other persons with the child in the walker or the accidents resulting from abuse and misuse by children able to walk. 1.5 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only. 1.6 The following precautionary caveat pertains only to the test method portion, Section 7, of this consumer safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM F977-2011a婴儿学步车的标准消费者安全规范

1.1 This consumer safety specification covers performance requirements, test methods, and marking requirements to promote safe use of the infant walker (see 3.1). 1.2 This consumer safety specification is intended to minimize accidents to children resulting from normal use and reasonably foreseeable misuse or abuse of walkers. 1.3 No walker produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein. 1.4 This consumer safety specification is not intended to address accidents and injuries resulting from the interaction of other persons with the child in the walker or the accidents resulting from abuse and misuse by children able to walk. 1.5 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only. 1.6 The following precautionary caveat pertains only to the test method portion, Section 7, of this consumer safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM F977-2011b婴儿学步车消费者安全标准规范

1.1 This consumer safety specification covers performance requirements, test methods, and marking requirements to promote safe use of the infant walker (see 3.1). 1.2 This consumer safety specification is intended to minimize accidents to children resulting from normal use and reasonably foreseeable misuse or abuse of walkers. 1.3 No walker produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein. 1.4 This consumer safety specification is not intended to address accidents and injuries resulting from the interaction of other persons with the child in the walker or the accidents resulting from abuse and misuse by children able to walk. 1.5 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only. 1.6 The following precautionary caveat pertains only to the test method portion, Section 7, of this consumer safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM F977-2012婴儿学步车的标准消费者安全规范

1.1 This consumer safety specification covers performance requirements, test methods, and marking requirements to promote safe use of the infant walker (see 3.1). 1.2 This consumer safety specification is intended to minimize accidents to children resulting from normal use and reasonably foreseeable misuse or abuse of walkers. 1.3 No walker produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein. 1.4 This consumer safety specification is not intended to address accidents and injuries resulting from the interaction of other persons with the child in the walker or the accidents resulting from abuse and misuse by children able to walk. 1.5 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only. 1.6 The following precautionary caveat pertains only to the test method portion, Section 7, of this consumer safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM F977-2018婴儿学步车用户安全使用标准规范

1.1x00a0;This consumer safety specification covers performance requirements, test methods, and marking requirements to promote safe use of the infant walker (see 3.1). 1.2x00a0;This consumer safety specification is intended to minimize accidents to children resulting from normal use and reasonably foreseeable misuse or abuse of walkers. 1.3x00a0;No walker produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein. 1.4x00a0;This consumer safety specification is not intended to address accidents and injuries resulting from the interaction of other persons with the child in the walker or the accidents resulting from abuse and misuse by children able to walk. 1.5x00a0;The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only. 1.6x00a0;The following precautionary caveat pertains only to the test method portion, Section 7, of this consumer safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.7x00a0;This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

EN 1273-2005儿童使用和保育用品.婴儿学步车的安全性要求和试验方法

This European Standard specifies safety requirements and test methods for baby walking frames into which a child is placed, and intended to be used from when the child is able to sit up by itself until the child is able to walk by itself.This European Standard does not apply to baby walking frames for therapeutic and curative purposes and to those baby walking frames relying on inflatable parts to support the child. NOTE Baby walking frames relying solely on inflatable parts to support the child are excluded from the scope of this standard because of the problem of retaining rigidity of the structure.This European Standard meets the general safety requirement of Directive 2001/95/EC for the risks it covers (source: 09/18/EGEntsch 2008-12-22, Official Journal of the European Union No. L, p. 30).

JS 1273-2013儿童使用和护理用品.婴儿学步车.安全要求和试验方法

This Jordanian Standard specifies safety requirements and test methods for baby walking frames into which a child is placed, and intended to be used from when the child is able to sit up by itself until the child is able to walk by itself. This Standard does not apply to baby walking frames for therapeutic and curative purposes and to those baby walking frames relying on inflatable .