纤维光学环行器检测

发布时间：2024-06-21 作者：中析研究所浏览：

GB/T 18478-2001纤维光学环行器

本标准规定了纤维光学环行器的相关定义、产品分类、技术要求、试验方法、质量评定程序以及标志、包装、贮存等条件。本标准适合于应用在光纤通信和其他光纤技术的环行器。

GB 51123-2015光纤器件生产厂工艺设计规范

本规范适用于光纤器件生产厂新建、扩建和改建的工艺设计。

JJF 1690-2018偏振依赖损耗测试仪校准规范

本规范适用于偏振依赖损耗测试仪的校准。

YD/T 1066-2000纤维光学环行器技术条件

本标准规定了纤维光学环行器的产品分类、技术要求、特性试验、检验、包装、标志、运输和贮存等。\t本标准适用于光纤通信和其他光纤技术应用的纤维光学环行器。

GSO IEC 61753-091-2-2013纤维光学互连器件和无源元件.性能标准.第091-2部分：C类非连接单模纤维光学尾纤环行器.受控环境

IEC 61753-091-2:2012 contains the minimum test and measurement requirements and severities which a fibre optic circulator as specified by IEC 62077 should satisfy in order to be categorized as meeting the requirements of circulators used in controlled environments as specified in IEC 61753-1. Keywords: fibre optic circulator

GSO IEC 62077-2014纤维光学互连器件和无源元件.纤维光学环行器.总规范

This International Standard applies to circulators used in the field of fibre optics bearing all of the following features: – they are non-reciprocal optical devices, in which each port is either an optical fibre or fibre optic connector; – they are passive devices in accordance with the categorization and definition provided in IEC 62538; – they have three or more ports for directionally transmitting optical power.

DIN EN 61300-3-29-2015纤维光学互连器件和无源元件. 基本试验和测量程序. 第3-29部分: 检查和测量. DWDM器件的光谱传递特性 (IEC 61300-3-29-2014); 德文版本EN 61300-3-29-2014

This part of IEC 61300 identifies two basic measurement methods for characterizing the spectral transfer functions of DWDM devices.

DS/EN 62077-2010纤维光学互连器件和无源元件.纤维光学环行器.总规范

IEC 62077:2010(E) applies to fibre optic circulators, which are: - non-reciprocal optical devices; - passive components; - have three or more ports for directionally transmitting optical power. This standard establishes circulator requirements and quality assessment procedures. The changes with respect to the previous edition are listed as: - having substantially increased the number of terms; - having added an informative annex for examle of filtering technologies; - having deleted quality assessment procedures.

BS EN 61300-3-32-2006纤维光学互连装置和无源元件.基本试验和测量程序.检查和测量.无源光学元件的偏振模式色散测量

This part of IEC 61300 presents a number of alternative methods for measuring thepolarization mode dispersion (PMD) of a passive fibre optic device under test (DUT). Thesemethods typically measure PMD using either a frequency domain or time domain approach. Inthe frequency domain, the polarization properties of the DUT are analysed. In the time domainapproach, the pulse delay or broadening is observed.This procedure will cover measurements of both broadband, and narrowband densewavelength division multiplexing (DWDM) passive fibre optic devices. Differences betweenmeasurement practices for these varied classes of passive fibre optic devices will be noted inthe text.This procedure can be applied to laboratory, factory and field measurements of PMD inpassive fibre optic devices. Limitation of the application of some methods will be noted in thetext when necessary.This procedure can be applied to a transmissive or reflective DUT. In the latter case, the DUTconnection is via a coupler or circulator, which should have a known very low PMD value.

BS EN 61753-091-3-2004纤维光学互连器件和无源元件性能标准.U类单模纤维光学有抽头的循环器.非受控环境

This part of IEC 61753 contains the minimum requirements and severities which a fibre optic circulator shall satisfy in order to be categorised as meeting the requirements of circulator devices used in uncontrolled environments. The requirements cover non-connectorised single mode circulators for category U - Uncontrolled environments.

BS EN 61753-092-6-2007纤维光学互连器件和无源元件性能标准.第092-6部分:O类非连接式单模循环器.非受控环境和连续试验

This part of IEC 61753 contains the minimum test and measurement requirements andseverities which a fibre optic circulator should satisfy in order to be categorized as meeting therequirements of circulator devices used in outside plant environments. The requirements covernon-connectorized single-mode circulators for caterogy O used in an uncontrolled environmentand a sequential test.