轻质混凝土板材检测

GB/T 31543-2015单层卷材屋面系统抗风揭试验方法

本标准规定了模拟抗风揭拉拔测试方法、静态正压或负压抗风揭测试方法和动态负压抗风揭测试方法三种测试单层卷材屋面系统抗风揭性能的试验方法。本标准适用于采用机械固定或满粘施工的单层卷材屋面系统。

GB/T 34327-2017建筑幕墙术语

本标准规定了建筑幕墙的通用术语和定义。本标准适用于各种类型的建筑幕墙。

GB/T 37260.1-2018箱型轻钢结构房屋 第1部分:可拆装式

GB/T 37260的本部分规定了可拆装式箱型轻钢结构房屋的术语和定义、规格和标记、一般要求、材料及构件、工艺及性能、试验方法、检验规则以及标志、包装、运输和贮存。本部分适用于具有建筑使用功能，可独立使用的或作为一个建筑体组合模块的可拆装式箱型轻钢结构房屋。

CJJ 122-2017游泳池给水排水工程技术规程

本规程适用于新建、扩建、改建的游泳池及类似水环境水池的给水排水工程的设计、施工、检测、调试、验收、运行、维护和管理。

JC/T 2122-2012轻质混凝土吸声板

本标准规定了轻质混凝土吸声板的术语和定义、分类、规格尺寸和标记、一般规定、技术要求、试验方法、检验规则以及标志、包装、运输和贮存等。本标准适用于以水泥为胶凝材料，以轻集料为集料，加入水和外加剂，经搅拌、入模成型、养护制成的具有吸声功能的制品，可用于建筑、公路、铁路、市政等工程。

LY/T 2389-2014轻型木结构建筑覆面板用定向刨花板

本标准规定了轻型木结构建筑覆面板用定向刨花板的术语和定义、分类、要求、试验方法、抽样方法及判定规则、工厂质量控制、标识、包装、运输和贮存等。本标准适用于轻型木结构建筑覆面板用的定向刨花板，包括用作屋面板、墙面板和楼面板的定向刨花板。本标准涉及的定向刨花板其胶合等级为暴露I级。

JG/T 432-2014建筑结构保温复合板

本标准规定了建筑结构保温复合板的术语和定义、分类和标记、材料、要求、试验方法、检验规则、标志及包装、运输与贮运等。本标准适用于建筑非承重围护结构用保温复合墙板。

JGJ 3-2010高层建筑混凝土结构技术规程

本规程适用于10层及10层以上或房屋高度大于28m的住宅建筑以及房屋高度大于24m的其他高层民用建筑混凝土结构。非抗震设计和抗震设防烈度为6至9度抗震设计的高层民用建筑结构，其适用的房屋大高度和结构类型应符合本规程的有关规定。本规程不适用于建造在危险地段以及发生震断裂小避让距离内的高层建筑结构。

JGJ 209-2010轻型钢结构住宅技术规程

本规程适用于以轻型钢框架为结构体系,并配套有满足功能要求的轻质墙体、轻质楼板和轻质屋面建筑系统,层数不超过6层的非抗震设防以及抗震设防烈度为6~8度的轻型钢结构住宅的设计、施工及验收。

JGJ/T 229-2010民用建筑绿色设计规范

本标准适用于新建、改建和扩建民用建筑的绿色设计。

JGJ/T 275-2013密肋复合板结构技术规程

本规程适用于8层及8层以下且房屋高度不超过24m的多层密肋复合板结构及9层及9层以上或房屋高度超过24m的高层密肋复合板结构。非抗震设计和抗震设防烈度为6度至8度抗震设计的密肋复合板结构,其适用的房屋大高度应符合本规程的有关规定。本规程不适用于建造在危险地段以及发震断裂小避让距离内的密肋复合板结构。

JGJ 367-2015住宅室内装饰装修设计规范

本规范适用于住宅的室内装饰装修设计，不适用属于历史文物保护的住宅的室内装饰装修设计。

JGJ/T 398-2017装配式住宅建筑设计标准

本标准适用于采用装配式建筑结构体与建筑内装体集成化建造的新建、改建和扩建住宅建筑设计。

ASTM C1153-2010用红外线影象为屋面防潮定位的标准实施规程

This practice is used to outline the minimum necessary elements and conditions to obtain an accurate determination of the location of wet insulation in roofing systems using infrared imaging. This practice is not meant to be an instructional document or to provide all the knowledge and background necessary to provide an accurate analysis. For further information, see ANSI-ASHRAE Standard 101 and ISO/DP 6781.3E. This practice does not provide methods to determine the cause of moisture or its point of entry. It does not address the suitability of any particular system to function capably as waterproofing.1.1 This practice applies to techniques that employ infrared imaging at night to determine the location of wet insulation in roofing systems that have insulation above the deck in contact with the waterproofing. This practice includes ground-based and aerial inspections. (Warning8212;Extreme caution shall be taken when accessing or walking on roof surfaces and when operating aircraft at low altitudes, especially at night.) (Warning8212;It is a good safety practice for at least two people to be present on the roof surface at all times when ground-based inspections are being conducted.) 1.2 This practice addresses criteria for infrared equipment such as minimum resolvable temperature difference, spectral range, instantaneous field of view, and field of view. 1.3 This practice addresses meteorological conditions under which infrared inspections shall be performed. 1.4 This practice addresses the effect of roof construction, material differences, and roof conditions on infrared inspections. 1.5 This practice addresses operating procedures, operator qualifications, and operating practices. 1.6 This practice also addresses verification of infrared data using invasive test methods. 1.7 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.8 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in 1.1.

EN 1992-1-1-2004欧洲法规2.混凝土结构设计.第1-1部分:一般规则和建筑规则［代替:CEN ENV 1992-1-3,CEN ENV 1992-1-4,CEN ENV 1992-1-5,CEN ENV 1992-1-6］

P Eurocode 2 applies to the design of buildings and civil engineering works in plain, reinforced and prestressed concrete. It complies with the principles and requirements for the safety and serviceability of structures, the basis of their design and verification that are given in EN 1990: Basis of structural design.

EN 15287-1-2007烟囱.烟囱的设计,安装和试用.第1部分:非密封房间加热器具用烟囱［代替:CEN EN 12391-1］

This European Standard describes the method of specifying the design, installation criteria for system chimneys, construction of custom built chimneys, and the relining of existing chimneys. It also gives information on commissioning of chimneys.This European Standard also deals with connecting flue pipes.This European Standard does not apply to freestanding chimneys covered by EN 13084-1.This European Standard excludes chimneys designated H (high positive pressure chimneys) and chimneys for room-sealed heating appliances. For the purpose of this European Standard the term \"installation\" includes construction.

DIN 4102-4-2016建筑材料和建筑构件的耐火性能.概要和分级的建筑材料、构件和特种构件的应用

This document contains catagorized results of fire tests of buildings materials, components and construction types. Due to the assignment to the classes of building materials according to DIN 4102 part 1 and the fire resistance classes of the other parts of DIN 4102 respectively, further fire tests for the verification of usability required by the building regulations are not necessary.