疾病控制样品检测

发布时间：2024-06-21 作者：中析研究所浏览：

GB 21551.2-2010家用和类似用途电器的抗菌、除菌、净化功能.抗菌材料的特殊要求

GB 21551的本部分规定了家用和类似用途电器（以下简称“家用电器”）中使用的抗菌材料、零部件的抗菌及抗霉菌（以下简称“抗菌”）性能试验方法和效果评价等。本部分适用于家用电器中使用的抗菌材料及相关抗菌零部件进行抗菌性能试验的方法和效果评价。

GB/T 27406-2008实验室质量控制规范.食品毒理学检测

本标准规定了食品毒理学检测实验室质量控制的管理要求、技术要求、过程控制要求和结果质量控制要求。本标准包括食品毒理学检测实验室从受理申请、样品采集、样品处理及样品检验到出具检验报告、解释结果及提出建议全过程的质量控制要求。本标准适用于食品毒理学检测实验室，亦可供其他毒理学检测实验室参考使用。

GB/T 27411-2012检测实验室中常用不确定度评定方法与表示

本标准规定了测量结果不确定度的四种评定方法。本标准适用于检测实验室的测量不确定度评定。

GBZ/T 232-2010核电厂职业照射监测规范

本标准规定了核电厂职业照射监测的一般要求、不同类别监测的技术要求及其监测结果评价和质量保证。本标准适用于为控制核电厂职业照射而进行的辐射监测。核电厂以外的其他核反应堆运行单位可参照使用。

WS/T 455-2014卫生检测与评价名词术语

本标准规定了卫生检测与评价实验室名词术语的分类和定义(或含义)。本标准适用于卫生检测与评价工作，特别是卫生检测技术标准(规范)的编写和实施。

SN/T 2853-2011闭合孢子虫病检疫技术规范

本标准规定了用于检测牡蛎闭合孢子虫病的临床诊断方法、组织印迹法、组织切片法、透射电镜法、PCR方法和核酸原位杂交等方法。本标准适用于闭合孢子虫病的流行病学调查、监测、诊断和出入境检验检疫。

RB/T 141-2018化学检测领域测量不确定度评定利用质量控制和方法确认数据评定不确定度

本标准规定了系统受控下基于质量控制和确认数据的测量不确定度评定。本标准适用于化学领域检测实验室的测量不确定度评定。

DIN EN 1948-3-2006固定源排放.PCDD/PCDF和类二氧芑质量浓度测定.第3部分:PCDD/PCDF标识和定量

The present Part of the Standard specifies the identification and quantificationprocedures of the sampled PCDDs/PCDFs. It is an integral part of the complete measurement procedure. The use of the other two parts of this Standard, EN 1948-1:2003 and EN 1948-2:2003, describing sampling and extraction and clean-up, respectively, is necessary for the determination of the PCDDs/PCDFs. This Standard has been designed to measure PCDD/PCDF concentrations at about 0,1 ng I-TEQ/m cube in stationary source emissions.

DIN EN ISO 18744-2016食物链的微生物学.新鲜绿叶蔬菜和浆果类水果中隐孢子虫和贾第鞭毛虫的检测和计数(ISO 18744-2016).德文版本EN ISO 18744-2016

This International Standard specifies a method that is applicable for the detection and enumeration of Cryptosporidium oocysts and Giardia cysts on or in food products that are described herein as fresh leafy green vegetables and berry fruits. With suitable controls, it may also be applicable for the examination of other fresh produce.

BS EN 12258-2-2004铝和铝合金.术语和定义.化学分析

This document defines general terms which are help-ful for the communication within the aluminium indus-try and its customers relating to the chemical analysis.\nA glossary (Annex A) comprises all terms in alpha-betical order which are defined in this document.\nNOTE Most of the definitions are taken from or closely adapted to ISO standards and/or VIM.

BS EN 62321-2009电工产品.6种管制产品含量水平的测定(铅,汞,镉,六价铬,多溴联苯,溴化联苯醚)

IEC 62321, which is an International Standard, specifies the determination of the levels oflead (Pb), mercury (Hg), cadmium (Cd), hexavalent chromium (Cr(VI)) contained in inorganicand organic compounds, and two types of brominated flame retardants, polybrominatedbiphenyls (PBB) and polybrominated diphenyl ethers (PBDE) contained in electrotechnicalproducts.This standard refers to the sample as the object to be processed and measured. The natureof the sample and the manner in which it is acquired is defined by the entity carrying out thetests and not by this standard.NOTE 1 Further guidance on obtaining representative samples from finished electronic products to be tested forlevels of regulated substances may be found in the future IEC Publicly Available Specification (PAS) for samplingdisjointment1.It is noted that the selection of the sample may affect the interpretation of the test results.This standard does not determine:• the definition of a “unit” or “homogenous material” as the sample;• the disassembly procedure employed for obtaining a sample;• assessment procedures.NOTE 2 Further guidance on assessment procedures may be found in the future IEC Technical SpecificationIEC/TS 62476