羊驼毛检测

发布时间：2024-06-21 作者：中析研究所浏览：

GB/T 11951-2018天然纤维术语

本标准根据纤维来源或组成界定了纺织用主要天然纤维的术语和定义，提供了相应的英文属名和俗称。本标准适用于纺织用天然纤维。

GB/T 16988-2013特种动物纤维与绵羊毛混合物含量的测定

本标准规定了使用投影显微镜对山羊绒、兔毛、马海毛、驼绒(毛)、牦牛绒(毛)、羊驼毛等绒毛类型的特种动物纤维、绵羊毛及其混合物中各组分纤维含量的测定方法。本标准适用于特种动物纤维、绵羊毛及其混合物。

GB/T 35025-2018羊驼毛

本标准规定了羊驼毛的术语和定义、产品特征、分级技术要求、检验方法、包装、标识、贮存、运输等。本标准适用于羊驼毛的生产、分级、加工、流通和检验。

SN/T 3981.9-2015进出口纺织品质量符合性评价方法纺织原料第9部分:特种动物毛

SN/T 3981的本部分规定了进出口特种动物毛符合性评价的要求、程序和评价报告内容。本部分适用于各类进出口原、过轮、洗净及分梳动物毛，如骆驼绒、牦牛绒、兔毛、马海毛、羊驼毛等特种动物毛法规性要求和非法规性要求的质量符合性评价。不适用羊毛、羊绒的质量符合性评价。

FZ/T 01057.1-2007纺织纤维鉴别试验方法第1部分:通用说明

FZ／T 01057的本部分是有关纺织纤维鉴别试验方法的通用说明。本部分规定了纺织纤维鉴别试验方法的一些共同性的技术要求并给出了纤维鉴别试验的一般性程序。本部分适用于纺织纤维的鉴别。

FZ/T 01162-2022纺织品定量化学分析聚乙烯纤维与某些其他纤维的混合物(石蜡油法)

本文件规定了采用石蜡油法测定去除非纤维物质后两组分混合物中聚乙烯纤维含量的方法。本文件适用于聚乙烯纤维与动物毛纤维(绵羊毛、山羊绒、羊驼毛和马海毛)、纤维素纤维(棉、亚麻、苎麻、粘胶纤维、莫代尔纤维、莱赛尔纤维和铜氨纤维)、蚕丝(桑蚕丝、柞蚕丝)和合成纤维(聚酯纤维、聚酰胺纤维、聚丙烯腈纤维、芳香族聚酰胺纤维和聚丙烯纤维)的二组分混合物。

ASTM D2252-2018羊驼毛类型细度的标准规范

4.1x00a0;This specification for fineness is intended as a guide for production, preparation, and marketing (Note 1) by comparing the average fiber diameter of a measured specimen with the fineness specifications for the various types listed in Table 1. The standard deviation which expresses measured variability of a specimen may be compared with the average shown in Table X2.1. Note 1:x00a0;Test Method D2130 does not include any values for the precision to be expected in the testing of alpaca fibers. In an interlaboratory test in which six laboratories each made one test on each of six type samples, HTB-CB, HAXB-CB, HAAB-CB, HAB-CB, HLPB-CL, and HSKB-CL, the coefficient of variation of the average fiber diameters between laboratories, including test variation, was 3.2, 4.7, 3.8, 4.5, 2.2, and 0.938201;% for the respective alpaca types. 1.1x00a0;This specification is applicable in the classification of alpaca into types according to fineness. 1.2x00a0;The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3x00a0;This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4x00a0;This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.