便装裤检测

便装裤检测项目报价？  解决方案？  检测周期？  样品要求？

点 击 解 答

GB/T 15557-2008服装术语

本标准规定了服装及服饰工业常用的术语、定义或说明。本标准适用于服装和服饰设计、生产、技术、教学、贸易及其相关领域。

TB/T 3453.3-2016动车组词汇 第3部分:部件和系统

本部分界定了动车组各部件和系统用词汇的术语、英语对应词和定义。本部分适用于动车组的标准、技术文件和科技出版物。

ASTM D7021-2005浴衣、晨衣、女式长睡衣、便装和宽松薄裤织物的标准性能规范

1.1 This performance specification covers fabrics used in bathrobes, dressing gowns, negligee, nightgown, and pajamas. 1.2 These requirements apply to the length and width directions for those properties where each fabric direction is pertinent.1.3 The following safety hazards caveat pertains only to the test methods described in this performance specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.

ASTM D7021-2005(2012)浴衣晨衣女式长睡衣便装和宽松薄裤织物的标准性能规范

Fabrics intended for this end-use should meet all of the requirements listed in Table 1. It should be recognized that fabric can be produced utilizing an almost infinite number of combination of construction variables (e.g., type of fibers, percentage of fibers, yarn twist, yarn number, warp and pick count, chemical and mechanical finishes). Additionally, fashion or aesthetics dictate that the ultimate consumer may find acceptable articles made from fabrics that do not conform to all of the requirements in Table 1. Hence, no single performance specification can possibly apply to all the various fabrics that could be utilized for this end-use. The uses and significance of particular properties and test methods are discussed in the appropriate sections of the specified test methods. TABLE 1 Specification Requirements CharacteristicMinimum Requirements Section Sheer FabricsNon-Sheer Fabrics Breaking strength (CRE)A9; 9;67 N (15 lbf)8.9 N (20 lbf) 5.1 Tearing strength (CRE)A9;9;4.4 N (1 lbf)6.7 N (1.5 lbf) 5.2 Yarn distortion: Satins2.5 mm (0.1 in.), max at 4.4 N (1 lbf) load All other1 mm (0.05 in.), max at 4.4 N (1 lbf) load Resistance to Yarn slippageA 5.4 (6 mm (x00BC; in.) separation)9;9;9;44 N (10 lbf)67 N (15 lbf) Bursting strength, KnitA9;133 N (30 lbf)9;222 N (50 lbf) 5.5 Dimensional Change - Woven Laundering9;9;3 %, max 5.6.1 Drycleaning9;2 %, max 5.6.2 D 1......