建筑石膏参数检测

发布时间：2024-06-21 作者：中析研究所浏览：

GB/T 17669.4-1999建筑石膏净浆物理性能的测定

本标准规定了建筑石膏净浆的标准稠度用水量和凝结时间的测定方法。

CJJ/T 230-2015排水工程混凝土模块砌体结构技术规程

本规程适用于内压不大于0.06MPa的矩形排水管渠和检查井、内水深度不大于4m的排水构筑物等排水工程混凝土模块砌体结构的设计、施工及验收。

HB/Z 248-1993飞机装配型架设计

本标准规定了飞机及其他飞行器装配型架（以下简称型架）设计的主要技术要点。\n　　本标准适用于飞机装配型架设计。

JC/T 2581-2021建筑石膏煅烧设备沸腾炉

本文件规定了建筑石膏煅烧设备沸腾炉的术语和定义、型号和基本参数、技术要求、试验方法、检验规则以及标志、包装、运输和贮存。本文件适用于以热风为热源的建筑石膏煅烧设备沸腾炉(以下简称沸腾炉)。

SB/T 10647-2011干混砂浆质量管理规程

本标准规定了总则、术语、分类与标记、生产过程质量管理、产成品质量管理、运输和贮存质量管理、施工过程质量管理。本标准适用于干混砂浆在生产、检验、物流及施工过程中的质量控制与管理。

SN/T 2297.1-2009进出口石膏及石膏制品化学分析方法第1部分:锶含量的测定

SN/T 2297的本部分规定了电感耦合等离子原子发射光谱、电感耦合等离子体质谱法和火焰原子吸收光谱法测定石膏及石膏制品中锶含量的方法。

JG/T 169-2016建筑隔墙用轻质条板通用技术要求

本标准规定了建筑隔墙用轻质条板(以下简称轻质条板)的术语和定义、分类与标记、一般要求、要求、试验方法、检验规则、标志、运输和贮存。本标准适用于一般工业与民用建筑非承重隔墙轻质条板的生产与检验。

JGJ/T 181-2009房屋建筑与市政基础设施工程检测分类标准

本标准适用于房屋建筑和市政基础设施工程检测的分类。

JGJ/T 220-2010抹灰砂浆技术规程

本规程适用于新建、改建、扩建和既有建筑的一般抹灰工程用砂浆的配合比设计、施工及质量验收。

JGJ/T 240-2011再生骨料应用技术规程

本规程适用于再生骨料在建筑工程中的应用。

JGJ/T 261-2011外墙内保温工程技术规程

本规程适用于以混凝土或砌体为基层墙体的新建、扩建和改建居住建筑外墙内保温工程的设计、施工及验收。

DB31/T 666-2012免煅烧脱硫石膏基衍生产品(粉刷砂浆、石膏砌块和土壤固化剂)应用技术规程

本标准规定了免煅烧脱硫石膏基衍生产品(粉刷砂浆、石膏砌块和土壤固化剂)的术语和定义、材料、设计、施工和验收要求。本标准适用于：1)　新建、改建、扩建及房屋修缮的民用建筑内墙和顶棚抹灰为主的免煅烧脱硫石膏基粉刷砂浆工程；2)　抗震设防烈度为8度及8度以下地区的工业与民用建筑中采用石膏砌块砌筑的室内非承重墙体；3)　新建和改建各级城市道路、公路、建筑地基的固化土。

EN 1996-1-2-2005欧洲规范6.砖石工程结构设计.第1-2部分:一般规则.结构防火设计

(1)This Part 1-2 of EN 1996 deals with the design of masonry structures for the accidental situation of fire exposure, and is intended to be used in conjunction with EN 1996-1-1, EN 1996-2, 1996-3 and EN 1991-1-2.This part 1-2 only identifies differences from, or supplements to, normal temperature design. (2)This Part 1-2 deals only with passive methods of fire protection. Active methods are not covered. (3)This Part 1-2 applies to masonry structures which, for reasons of general fire safety, are required to fulfil certain functions when exposed to fire, in terms of: avoiding premature collapse of the structure (load bearing function); limiting fire spread (flames, hot gases, excessive heat) beyond designated areas (separating function) (4)This Part 1-2 gives principles and application rules for designing structures for specified requirements in respect of the aforementioned functions and levels of performance. (5)This Part 1-2 applies to structures, or parts of structures, that are within the scope of EN 1996-1-1, EN 1996-2 and EN 1996-3 and are designed accordingly. (6)PThis Part 1-2 does not cover masonry built with Natural Stone units to EN771-6 (7)PThis Part 1-2 deals with the following; non-loadbearing internal walls; non-loadbearing external walls; loadbearing internal walls with separating or non-separating functions; loadbearing external walls with separating or non-separating functions.

DIN 4102-4-2016建筑材料和建筑构件的耐火性能.概要和分级的建筑材料、构件和特种构件的应用

This document contains catagorized results of fire tests of buildings materials, components and construction types. Due to the assignment to the classes of building materials according to DIN 4102 part 1 and the fire resistance classes of the other parts of DIN 4102 respectively, further fire tests for the verification of usability required by the building regulations are not necessary.

DIN 4109-33-2016建筑物隔声. 第33部分: 隔声验证使用数据 (组件目录). 木结构, 轻型结构和干墙

This standard contains sound insulation specifications of components and structures for timber construction, lightweight construction and dry walling, which may be used without acoustic testing in the calculation procedures stated in DIN 4109-2 for the verification of the requirements of DIN 4109-1.

DIN 18180-2014石膏板.类型和要求

The standard applies to factory-produced gypsum plasterboards which are made of two sheets of mill-board affixed firmly to a layer of gypsum plaster between them. Gypsum plasterboards for various applications are defined, including those used as dry lining with or without additional fire resistance properties and those used as baseboards for plaster. Dimensions, mass in relation to surface, failure loads and degrees of deflection are given.

DIN EN 1996-1-2-2011欧洲法规6:圬工结构的设计.第1-2部分:一般规则.防火结构设计.德文版本EN 1996-1-2-2005 + AC-2010

This Part 1-2 of EN 1996 deals with the design of masonry structures for the accidental situation of fire exposure, and is intended to be used in conjunction with EN 1996-1-1, en 1996-2, 1996-3 and EN 1991-1-2. This part 1-2 only identifies differences from, or supplements to, normal temperature design.

DIN-Fachbericht CEN/TR 15125-2005内部水泥和/或石灰抹灰系统的设计、制备和应用

The Technical Report concerns the design, preparation and application of internal plaster and plastering systems based on cement and/or lime for internal plastering on all types of background used under normal conditions.#,,#

BS EN 1996-1-2-2005欧洲规范 6.砖石工程结构的设计.一般规则.结构防火设计

(1)P This Part 1-2 of EN 1996 deals with the design of masonry structures for the accidentalsituation of fire exposure, and is intended to be used in conjunction with EN 1996-1-1, EN1996-2, 1996-3 and EN 1991-1-2. This part 1-2 only identifies differences from, orsupplements to, normal temperature design.(2)P This Part 1-2 deals only with passive methods of fire protection. Active methods are notcovered.(3)P This Part 1-2 applies to masonry structures which, for reasons of general fire safety, arerequired to fulfil certain functions when exposed to fire, in terms of:- avoiding premature collapse of the structure (load bearing function)- limiting fire spread (flames, hot gases, excessive heat) beyond designated areas(separating function)(4)P This Part 1-2 gives principles and application rules for designing structures for specifiedrequirements in respect of the aforementioned functions and levels of performance.(5)P This Part 1-2 applies to structures, or parts of structures, that are within the scope ofEN 1996-1-1, EN 1996-2 and EN 1996-3 and are designed accordingly.(6)P This Part 1-2 does not cover masonry built with Natural Stone units to EN771-6(7)P This Part 1-2 deals with the following:- non-loadbearing internal walls.- non-loadbearing external walls.- loadbearing internal walls with separating or non-separating functions.- loadbearing external walls with separating or non-separating functions.