电主轴相关组件检测

电主轴相关组件检测项目报价？  解决方案？  检测周期？  样品要求？

点 击 解 答

GB/T 34880.3-2018五轴联动加工中心检验条件 第3部分:技术条件

GB/T 34880的本部分规定了五轴联动加工中心的设计、制造、检验和验收要求。本部分适用于线性行程至2 000 mm的五轴联动加工中心(以下简称机床)。线性轴线行程超过2 000 mm的五轴联动加工中心也可参照使用。

DIN 69888-2008旋转工具设备的平衡用要求

This Standard specifies requirements for balancing of tool systems with interfaces HSK 25 to HSK 100 according to DIN 69063-1, DIN 69063-2, DIN 69063-5, DIN 69063-6, DIN 69893-1, DIN 69893-2, DIN 69893-5 and DIN 69893-6 on the basis of the particular operating speed. The interfaces HSK 125 and HSK 160 are not covered by this Standard, it is recommend to apply the limiting values for HSK 100. This Standard can be applied analogously to tool systems with interfaces and tool holders such as ABS, CAPTO, KM, SK and parallel shank. In this case allowance shall be made for the constructional characteristics of the interfaces and tool holders.

DIN EN 848-2-2013木工机械的安全性.带旋转工具的单面模压机械.第2部分:单心轴手动进料/一体进料镂铣机.德文版本EN 848-2-2007+A2-2012

This document specifies all significant hazards, hazardous situations and events as listed in Clause 4 which are relevant to stationary and displaceable single spindle hand fed/integrated fed routing machines with fixed head but allowing only movement along the axis of the tool during machining hereinafter referred to as \"machines\" designed to cut solid wood, chip board,fibreboard,plywood and also these materials if they are covered with plastic laminate,edgings or veneer when they are used as intended and under the conditions foreseen by the manufacturer including reasonably foreseeable misuse.

DIN EN 61360-4-2005电子元器件标准数据元素类型和相关分类模式.第4部分:IEC标准数据元素类型和元器件分类的基准集

This standard specifies:-the definitions of data element types for electric components and materials used in electrotechnical equipment and systems;-the definitions of the component classes with associated classification scheme

DIN EN 61800-7-201-2016可调速电驱动设备.第7-201部分:电驱动设备轮廓的通用接口和使用.1型轮廓规范(IEC 61800-7-201-2015).英文版本EN 61800-7-201-2016

This part of IEC 61800-7 specifies profile type 1 for Power Drive Systems (PDS). Profile type 1 can be mapped onto different communication network technologies.