泡沫设备和泡沫液检测

泡沫设备和泡沫液检测项目报价？  解决方案？  检测周期？  样品要求？

点 击 解 答

GB/T 5907.5-2015消防词汇 第5部分:消防产品

GB/T 5907的本部分界定了消防产品的常用术语和定义。本部分适用于消防管理、消防标准化、消防工程、消防科学研究、教学、咨询、出版及其他有关工作领域。

GB 20031-2005泡沫灭火系统及部件通用技术条件

本标准规定了泡沫灭火系统及部件（包括泡沫比例混合器、泡沫比例混合装置、低倍数空气泡沫产生器、高背压泡沫产生器、泡沫喷头、泡沫钩管、泡沫炮、泡沫枪、中倍数泡沫产生器、高倍数泡沫产生器、泡沫消火栓、单向阀、控制阀门、过滤器、控制盘、控制柜、半固定式（轻便式）泡沫灭火装置、连接软管、泡沫消火栓箱、闭式泡沫-水喷淋系统等）的性能要求、试验方法、检验准则、包装、运输贮存要求等。 本标准适用于各类泡沫灭火系统及部件。

GB 50074-2014石油库设计规范

本规范适用于新建、扩建和改建石油库的设计。本规范不适用于下列易燃和可燃液体储运设施:1 石油化工企业厂区内的易燃和可燃液体储运设施;2 油气田的油品站场(库);3 附属于输油管道的输油站场;4 地下水封石洞油库、地下盐穴石油库、自然洞石油库、人工开挖的储油洞库;5 独立的液化烃储存库(包括常温液化石油气储存库、低温液化烃储存库);6 液化天然气储存库;7 储罐总容量大于或等于1200000m<上标3>,仅储存原油的石油储备库。

DIN EN 15767-3-2010消防泵供喷射灭火剂的便携式设备.便携式监控器.第3部分:泡沫装置;德文版本EN 15767-3-2010

This European Standard applies to foam devices used in conjunction with portable monitors. In addition to the requirements given in EN 15767-1, this part of this European standard applies to devices designed for aspirating air and projecting low expansion foam and, in some cases, inducting foam concentrate. It specifies requirements for safety, performance, classification and designation, as well as test methods, instructions for use and maintenance and marking.

DIN EN 16327-2014消防. 正压配比系统(PPPS)和压缩空气泡沫系统(CAFS); 德文版本EN 16327-2014

The document contains safety and performance requirements for positive pressure foam proportioning systems (PPFPS) and compressed air foam systems (CAFS). In these systems either additives (e. g. in positive pressure foam systems) or additives and compressed gases - normally compressed air - (e. g. in compressed air foam arrangements) are added to the water after the fire-fighting centrifugal pump, in each case under pressure for a continuous operation. These systems are fixed installed in fire fighting vehicles.

DIN EN 16712-1-2015由消防泵提供喷射灭火剂的便携式设备. 便携式泡沫设备. 第1部分: PN 16电感器; 德文版本EN 16712-1-2015

This standard defines requirements and tests which apply to inductors PN 16 which are used to proportion foam liquids or other additives to the water stream and work according to the Venturi principle.

DIN EN 16712-2-2015由消防泵提供喷射灭火剂的便携式设备. 便携式泡沫设备. 第2部分: 吸液管; 德文版本EN 16712-2-2015

This document specifies performance requirements and test methods for pick-up tubes. This document applies to pick-up tubes from DN 20 to DN 50 which are used for the suction of foam concentrate or additives and defines their requirements and test procedures. Pick-up tubes are especially used for the suction of foam concentrate or additives with inductors in accordance with EN 16712-1. Pick-up tubes can also be used for the suction of other substances (e. g. absorbents).

DIN EN 16712-3-2015由消防泵提供喷射灭火剂的便携式设备. 便携式泡沫设备. 第3部分: PN 16低倍数和中倍数手持式泡沫支管; 德文版本EN 16712-3-2015

This document applies to handheld foam branchpipes for low and medium expansion foam used by fire and rescue services and defines their specification and test procedures.NOTE In this document, the term "branchpipe" also refers to "handheld foam branchpipes".

DIN EN ISO 13702-2015石油和天然气工业.海上生产设备着火和爆炸的控制和减弱.要求和指南(ISO 13702-2015); 英文版本EN ISO 13702-2015

This International Standard describes the objectives and functional requirements for the control and mitigation of fires and explosions on offshore installations used for the development of hydrocarbon resources. This International Standard is applicable to: - fixed offshore structures; - floating systems for production, storage and offloading; - petroleum and natural gas industries. Mobile offshore units as defined in this International Standard and subsea installations are excluded, although many of the principles contained in this International Standard can be used as guidance. This International Standard is based on an approach where the selection of control and mitigation measures for fires and explosions is determined by an evaluation of hazards on the offshore installation. The methodologies employed in this assessment and the resultant recommendations will differ depending on the complexity of the production process and facilities, type of facility (i.e. open or enclosed), manning levels, and the environmental conditions associated with the area of operation. NOTE Statutory requirements, rules and regulations can in addition be applicable for the individual offshore installation concerned.

BS EN 15767-3-2010用消防泵喷射灭火剂的手持设备.手持监控器.泡沫设备

1.1 In addition to the requirements given in EN 15767-1, this part of this European standard applies todevices designed for aspirating air and projecting low expansion foam and, in some cases, inducting foamconcentrate. It specifies requirements for safety, performance, classification and designation, as well as testmethods, instructions for use and maintenance and marking.1.2 This European Standard is only applicable to foam devices which are manufactured after its date of publication.