一般用途钢丝绳和粗直径钢丝绳用非合金钢丝检测

一般用途钢丝绳和粗直径钢丝绳用非合金钢丝检测项目报价？  解决方案？  检测周期？  样品要求？

点 击 解 答

EN 1993-1-11-2006欧洲法规3.钢结构设计.第1-11部分:带受拉构件结构设计.合并勘误表-2009年4月

This standard also gives rules for determiningThe technical requirements for prefabricated tensioncomponents for assessingTheir safety, serviceability and durability.

EN 12385-4-2002钢丝绳.安全性.第4部分:一般提升设施用绞股绳

This Part of this European Standard specifies the particular materials, manufacturing and testing requirements forropes for general lifting applications.The particular hazards covered by this Part are identified in Clause 4.This Part of this European Standard does not establish requirements for information for use other than those givenin clause 7 of Part 1. Neither does it cover the requirements for ropes fitted with terminations.Minimum breaking force values for the more common classes, sizes and grades of rope are provided in tables 5 to17.

DIN EN 10264-1-2012钢丝和钢丝制品.绳索用钢丝.第1部分:一般要求

This Standard defines the general requirements for steel wire intended for mechanical ropes.

DIN EN 12385-1-2009钢丝绳.安全性.第1部分:一般要求

This Part specifies the general requirements for the manufacture and testing of steel wire rope, whose particularrequirements are specified in the other Parts.Annex A gives the type testing regimes for rope produced in series.Annex B gives the testing requirements for wires taken from the rope when specified in other Parts of this standard.

DIN EN ISO 13628-5-2010石油和天然气工业.水下采油系统的设计和操作.第5部分:海底缆线

This part of ISO 13628 specifies requirements and gives recommendations for the design, material selection, manufacture, design verification, testing, installation and operation of umbilicals and associated ancillary equipment for the petroleum and natural gas industries. Ancillary equipment does not include topside hardware. Topside hardware refers to any hardware that is not permanently attached to the umbilical, above the topside hang-off termination.This part of ISO 13628 applies to umbilicals containing components, such as electrical cables, optical fibres, thermoplastic hoses and metallic tubes, either alone or in combination.This part of ISO 13628 applies to umbilicals for static or dynamic service, with surface-surface, surface-subsea and subsea-subsea routings.This part of ISO 13628 does not apply to the associated component connectors, unless they affect the performance of the umbilical or that of its ancillary equipment.This part of ISO 13628 applies only to tubes with the following dimensions: wall thickness, t < 6 mm, internal diameter, ID < 50,8 mm (2 in). Tubular products greater than these dimensions can be regarded as pipe/linepipe and it is expected that they be designed and manufactured according to a recognised pipeline/linepipe standard.

BS EN 12385-4-2002+A1-2008钢丝绳.安全性.通用提升设备用标准绳索

This Part of this European Standard specifies the particular materials, manufacturing and testing requirements forropes for general lifting applications.The particular hazards covered by this Part are identified in Clause 4.This Part of this European Standard does not establish requirements for information for use other than those givenin clause 7 of Part 1. Neither does it cover the requirements for ropes fitted with terminations.Minimum breaking force values for the more common classes, sizes and grades of rope are provided in tables 5 to17.

BS EN 12385-7-2002钢丝绳索.安全性.矿井转轴用的锁紧线圈钢丝索

This Part of this European Standard specifies the particular materials, manufacturing and testing requirements forfull-locked coil hoist and half-locked and full-locked coil guide ropes for mine shafts.The particular hazards covered by this Part are identified in Clause 4.For information only, typical breaking forces for both full-locked coil hoist ropes and half-locked and full-locked coilguide ropes, based on one particular combination of wire tensile strength grades in each case, are given in annexA (hoist ropes) and annex B (guide ropes) for some of the more common sizes.

BS EN 12385-9-2002钢丝绳.安全.载人索道设备用锁丝输送钢丝绳

This Part of this European Standard specifies the particular materials, manufacturing and testing requirements forlocked coil carrying ropes for cableway installations designed to carry persons.The particular hazards covered by this Part are identified in Clause 4.