鞋头防护鞋类性能要求检测

发布时间：2024-06-21 作者：中析研究所浏览：

LD 32-1992高温防护鞋

本标准规定了设计、制造高温防护鞋必须遵循的安个技术要求、试验方法、检验规则等。本标准适用于供治炼、铸造、金属热加工、焦化、工业炉窑等高温作业场所工人穿用的特种防护鞋。

ASTM F2413-2011带有防护(安全)鞋头的鞋类性能要求规范

1.1 This specification covers minimum requirements for the performance of footwear to provide protection against a variety of workplace hazards that can potentially result in injury. 1.2 This specification is not intended to serve as a detailed manufacturing or purchasing specification, but can be referenced in purchase contracts to ensure that minimum performance requirements are met. 1.3 Controlled laboratory tests used to determine compliance with the performance requirements of this specification shall not be deemed as establishing performance levels for all situations to which individuals may be exposed. 1.4 Any changes to the original components of safety toe footwear such as replacing or adding after market footbeds/inserts could cause failure to any or all parts of this standard rendering the ASTM marking invalid. 1.5 This specification is not applicable to overshoes with safety toe caps or strap on devices with safety toes. 1.6 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM F2413-2017带有防护(安全)鞋头的鞋类性能要求的标准规格

1.1x00a0;This specification covers minimum requirements for the performance of footwear to provide protection against a variety of workplace hazards that can potentially result in injury. 1.2x00a0;This specification is not intended to serve as a detailed manufacturing or purchasing specification, but can be referenced in purchase contracts to ensure that minimum performance requirements are met. 1.3x00a0;Controlled laboratory tests used to determine compliance with the performance requirements of this specification shall not be deemed as establishing performance levels for all situations to which individuals may be exposed. 1.4x00a0;Any changes to the original components of safety toe footwear such as replacing or adding after market footbeds/inserts could cause failure to any or all parts of this standard rendering the ASTM marking invalid. 1.5x00a0;This specification is not applicable to overshoes with safety toe caps or strap on devices with safety toes. 1.6x00a0;The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.7x00a0;This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.8x00a0;This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

DIN EN 15090-2012防火鞋

This standard specifies minimum requirements and test methods for the performance of three types of footwear for use by firefighters for fire suppression, general-purpose rescue, fire rescue and hazardous materials emergencies. This standard does not cover special personal protective equipment used in high-risk situations (for example, the conditions described in ISO 15538).