抗菌产品检测

抗菌产品检测项目报价？  解决方案？  检测周期？  样品要求？

点 击 解 答

GB/T 20944.1-2007纺织品 抗菌性能的评价 第1部分:琼脂平皿扩散法

GB/T 20944的本部分规定了采用琼脂平皿扩散法测定纺织品抗菌性能的定性试验和评价方法。 本部分适用于机织物、针织物、非织造织物和其他平面织物。纤维、纱线等可参照执行。 本部分不适用于抗菌剂在试验琼脂上完全不扩散的试样，也不适用于抗菌剂与琼脂起反应的试样。 本部分不涉及抗菌产品安全性的评价。

GB/T 20944.2-2007纺织品 抗菌性能的评价 第2部分:吸收法

GB/T 20944的本部分规定了采用吸收法测定纺织品抗菌性能的定量试验和评价方法。 本部分适用于羽绒、纤维、纱线、织物和制品等各类纺织产品。 本部分不涉及抗菌产品安全性的评价。

GB/T 20944.3-2008纺织品.抗菌性能的评价.第3部分:振荡法

GB／T 20944的本部分规定了采用振荡法测定纺织品抗菌性能的定量试验和评价方法。 本部分适用于羽绒、纤维、纱线、织物，以及特殊形状的制品等各类纺织产品，尤其适用于非溶出型抗菌纺织产品。 本部分不涉及抗菌产品安全性的评价。

GB/T 22925-2009纳米技术处理服装

本标准规定了纳米技术处理服装产品的术语和定义、要求、检测方法、检验分类规则，以及标志、包装、运输和贮存等技术特征。本标准适用于经纳米技术处理的，以纺织机织物为主要面料生产的功能性服装。该服装或其特定部位在生产加工过程中因使用了纳米技术而具有了防水、防油、易去污、抗菌、防紫外线等一种或几种功能。本标准不适用于婴幼儿服装。

GB 50687-2011食品工业洁净用房建筑技术规范

本规范适用食品加工和生产的新建、改建和扩建厂房中洁净用房的设计、施工、工程检测和工程验收。

LY/T 1926-2020人造板与木(竹)制品抗菌性能检测与分级

本文件规定了人造板与木(竹)制品的抗菌性能检测方法和分级的术语和定义、抗菌性能检测方法和分级。本文件适用于抗菌处理的人造板和各种抗菌木(竹)制品的抗菌性能检测和分级。本文件不涉及抗菌产品的安全性评价。

SN/T 2558.4-2012进出口功能性纺织品检验方法.第4部分：抗菌性能.平板琼脂法

SN/T 2558的本部分规定了采用琼脂平皿扩散法测定进出口纺织品抗菌性能的定性分析测试方法。本部分适用于机织物、针织物、非织造织物和其他平面织物。羽绒、纤维、纱线等可参照执行。本部分适用于溶出性、非溶出型抗菌纺织品。本部分不适用于抗菌剂在试验琼脂上完全不扩散的试样，也不适用于抗菌剂与琼脂起反应的试样。本部分不涉及抗菌产品安全性的评价。

SN/T 2558.9-2015进出口功能性纺织品检验方法 第9部分:抗菌性能 阻抗法

SN/T 2558的本部分规定了采用阻抗法测定纺织品抗菌性能的定量试验和评价方法。本部分适用于羽绒、纤维、纱线、织物及其制品等各类纺织产品。本部分不涉及抗菌产品安全性的评价。

ASTM E2897-2012使用体外猪皮肤评估手部卫生局部抗菌产品效果的标准指南

5.1x00a0;The guide may be used to demonstrate the effectiveness of topical antimicrobial products using pigskin as a surrogate for human skin and the cup scrub technique for sampling. 5.2x00a0;The techniques described can be used to simulate Test Method E1174 and will use the pigskin substrate to overcome limitations posed by exposure of human subjects to potentially pathogenic microorganisms, while offering the benefit of applicability to a wide variety of hand-washing conditions that cannot be simulated in test tubes. 5.3x00a0;Use of the pigskin surrogate offers less expensive and higher throughput screening. 1.1x00a0;This guide is designed to demonstrate the effectiveness of hand hygiene topical antimicrobial products using pigskin as a surrogate model. 1.2x00a0;Knowledge of microbiological techniques is required for these procedures. 1.3x00a0;This standard guide can be used to evaluate topical antimicrobial handwash or handrub formulations. 1.4x00a0;The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5x00a0;This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM E2897-2012(2017)利用体外猪皮评价手部卫生局部抗菌产品有效性的标准指南

5.1x00a0;The guide may be used to demonstrate the effectiveness of topical antimicrobial products using pigskin as a surrogate for human skin and the cup scrub technique for sampling. 5.2x00a0;The techniques described can be used to simulate Test Method E1174 and will use the pigskin substrate to overcome limitations posed by exposure of human subjects to potentially pathogenic microorganisms, while offering the benefit of applicability to a wide variety of hand-washing conditions that cannot be simulated in test tubes. 5.3x00a0;Use of the pigskin surrogate offers less expensive and higher throughput screening. 1.1x00a0;This guide is designed to demonstrate the effectiveness of hand hygiene topical antimicrobial products using pigskin as a surrogate model. 1.2x00a0;Knowledge of microbiological techniques is required for these procedures. 1.3x00a0;This standard guide can be used to evaluate topical antimicrobial handwash or handrub formulations. 1.4x00a0;The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5x00a0;This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.6x00a0;This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM E2897-2022使用离体猪皮肤评估手部卫生局部抗菌产品有效性的标准指南

1.1 This guide is designed to demonstrate the effectiveness of hand hygiene topical antimicrobial products using pigskin as a surrogate model. 1.2 Knowledge of microbiological techniques is required for these procedures. 1.3 This standard guide can be used to evaluate topical antimicrobial handwash or handrub formulations. 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

DIN EN ISO 16187-2013鞋和鞋类组件.评估抗菌活性的试验方法(ISO 16187-2013).德文版本EN ISO 16187-2013

This International Standard specifies quantitative test methods to determine the antibacterial activity of footwear.This International Standard is applicable to all footwear products regardless of the type of antibacterial agent used(organic, inorganic, natural or man-made) or the method of application (built-in, after-treatment or grafting).The user can select the most suitable of the following methods on determination of antibacterial activity:a) Qualitative method (halo test) This is the testing method to evaluation the antibacterial activity of footwear products treated with antibacterial finish by the existence of halos, and this is applicable when antibacterial finishing chemicals can easily diffuse into plate agar culture medium.b) Quantitative method (Absorption test) This is the testing method to evaluation the antibacterial activity of footwear products treated with antibacterial finish by making use of a bacteriostatic activity value or a bactericidal activity value.